LSIS S100 - Page 286

274
Index
Ｐ
P1+ terminals(+ DC link terminals) ............................... 20
P2P ....................................................................................................... 113
communication function ................................................... 113
master parameter ................................................................... 113
setting ................................................................................ 113, 114
slave parameter ....................................................................... 113
parameter
initializing the parameters ....................................................61
parameter settings ....................................................................53
password ..................................................................................... 154
parameter mode........................................................................... 43
parameter setting mode .......................................................44
part names ........................................................................................... 3
parts illustrated ................................................................................. 3
Peripheral devices ..................................................................... 253
phase-to-phase voltage ....................................................... 238
PID control
PID feedback ............................................................................. 233
PNP/NPN mode selection switch(SW1) ..................... 22
NPN mode(Sink) .........................................................................28
PNP mode(Source)....................................................................27
post-installation checklist ....................................................... 33
power terminal
P2+/B terminal ............................................................................20
U/V/W terminal ...........................................................................20
power terminal board wiring .............................................. 19
power terminals
R/S/T terminals ............................................................................20
Power-on Run ....................... Refer to
start at power-on
Preinsulated Crimp Terminal ............................................... 26
protocol ............................................................................................ 133
LS INV 485 protocol ............................................................... 133
PRT(Protection Function group) .................................... 197
Pulse output terminal ................. Refer to TO terminal
Ｑ
Q1 terminal ....................................................................................... 25
Quantizing ......................................................................................... 70
noise ..................................................................................................70
Ｒ
R/S/T terminals ......................................................... 20, 21, 237
reactor ....................................................................................... 12, 253
regenerated energy ................................................................. 107
remote operation ......................................................................... 85
[ESC] key .........................................................................................84
local operation ............................................................................85
Local/Remote Mode Switching .........................................84
Reset Restart ....................
refer to restarting after a trip
resonance frequency .............................................................. 110
frequency jump ....................................................................... 110
restarting after a trip ................................................................. 88
RS-232 ............................................................................................... 126
communication ....................................................................... 126
RS-485 ............................................................................................... 125
communication ....................................................................... 126
converter ..................................................................................... 126
integrated communication ..................................................77
signal terminal ..................................................................... 26, 77
RS-485 signal input terminal ...... Refer to S+/S-/SG
terminal
run prevention
Fwd ....................................................................................................86
Rev .....................................................................................................86
Ｓ
S+/S-/SG terminal ....................................................................... 26
S100 expansion common area parameter
control area parameter(Read/Write) ............................ 151
memory control area parameter(Read/Write) ........ 153
monitor area parameter (read only) ............................. 145
SA terminal ....................................................................................... 24
safety information ........................................................................... ii
safety input power terminal ..... Refer to SC terminal
safety inputA terminal ................... Refer to SA terminal
Safety inputB terminal ................... Refer to SB terminal
SB terminal ........................................................................................ 24