Learning to Perform Basic Operations
Key Name Description
[MODE] Key Used to switch between modes.
[PROG / Ent] Key Used to select, confirm, or save a parameter value.
Switch between codes or increase or decrease parameter values.
[LEFT] key
[RIGHT] key
Switch between groups or move the cursor during parameter
setup or modification.
[MULTI] Key Used to perform special functions, such as user code registration.
[ESC] Key
Used to cancel an input during parameter setup.
• Pressing the [ESC] key before pressing the [PROG / ENT] key
reverts the parameter value to the previously set value.
• Pressing the [ESC] key while editing the codes in any function
group makes the keypad display the first code of the function
group.
•
Pressing the [ESC] key while moving through the modes makes
the keypad display Monitor mode.
[FWD] Key Used to operate the motor in the forward direction.
[REV] Key Used to operate the motor in the reversed direction.
[STOP/RESET] Key
Used to stop motor operation.
Used to reset the inverter following fault or failure condition.
To Next Page
Loading...
Need help?
General
