LSIS S100 User Manual

vi
Table of
Contents
4.1.1 Keypad as the Source (KeyPad-1 setting) ...................................................... 66
4.1.2 Keypad as the Source (KeyPad-2 setting) ...................................................... 67
4.1.3 V1 Terminal as the Source ...................................................................................... 67
4.1.4 Setting a Frequency Reference with Input Voltage (Terminal I2) ...... 75
4.1.5 Setting a Frequency with TI Pulse Input ......................................................... 76
4.1.6 Setting a Frequency Reference via RS-485 Communication ............... 77
4.2 Frequency Hold by Analog Input ........................................................................................ 78
4.3 Changing the Displayed Units (Hz↔Rpm) ..................................................................... 78
4.4 Setting Multi-step Frequency ............................................................................................... 79
4.5 Command Source Configuration ........................................................................................ 81
4.5.1 The Keypad as a Command Input Device ..................................................... 81
4.5.2 Terminal Block as a Command Input Device (Fwd/Rev Run
Commands) ................................................................................................................. 81
4.5.3 Terminal Block as a Command Input Device (Run and Rotation
Direction Commands)............................................................................................ 82
4.5.4 RS-485 Communication as a Command Input Device ........................... 83
4.6 Local/Remote Mode Switching ............................................................................................ 84
4.7 Forward or Reverse Run Prevention .................................................................................. 86
4.8 Power-on Run ................................................................................................................................ 87
4.9 Reset and Restart ......................................................................................................................... 88
4.10 Setting Acceleration and Deceleration Times ............................................................... 89
4.10.1 Acc/Dec Time Based on Maximum Frequency ........................................... 89
4.10.2 Acc/Dec Time Based on Operation Frequency ........................................... 90
4.10.3 Multi-step Acc/Dec Time Configuration ......................................................... 91
4.10.4 Configuring Acc/Dec Time Switch Frequency ............................................ 93
4.11 Acc/Dec Pattern Configuration ............................................................................................ 94
4.12 Stopping the Acc/Dec Operation........................................................................................ 96
4.13 V/F(Voltage/Frequency) Control ......................................................................................... 97
4.13.1 Linear V/F Pattern Operation................................................................................ 97
4.13.2 Square Reduction V/F pattern Operation ...................................................... 98
4.13.3 User V/F Pattern Operation ................................................................................... 99
4.14 Torque Boost ................................................................................................................................ 101

LSIS S100 Specifications

General

Brand	LSIS
Model	S100
Category	DC Drives
Language	English