NTP-031
: System Turnup 363-206-305
Page 2 of 14 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
NOTE:
It is assumed that all DDM-2000 OC-12 shelves in the
system have passed the looped transmission test(s) and the
DDM-2000 OC-12 ring has been established, as required
(363-206-295,
DDM-2000 OC-12 Multiplexer, TARP
Release 7, User/Service Manual (TOP)—Volume II),
System Turnup: NTP-002
and
NTP-020
. It is also assumed
the DDM-2000 OC-3 Release 15 shelves have been
equipped and tested, (363-206-285,
DDM-2000 OC-3
Multiplexer, TARP Release 13 and Later, User/Service
Manual (TOP)—Volume II),
System Turnup: NTP-016
and
the OC-3 and/or OC-12 ring has been established, as
required,
System
Turnup: NTP-022
. It is assumed that all
DDM-2000 FiberReach OC-3 shelves in the system have
passed the looped transmission test(s),
System Turnup:
NTP-007
.
Determine the network configuration (for example, see Figure 1 or
Figure 3.)
DLP-531
2. Verify that the host DDM-2000 OC-12 shelf is equipped with TARP
Release 7 or Release 15 ring software. If not equipped with TARP
Release 7 or Release 15 software, upgrade the DDM-2000 OC-12
host shelf with proper software. Verify that the DDM-2000
FiberReach OC-3 shelf is equipped with TARP Release 4 ring
software.
3. Determine the optical loss of each optical span from office records
or by making the required measurements.
4.
NOTE:
The rtrv-eqpt: command retrieves the Equipage and
Version Report. This report lists the circuit pack type
and version information for one or more slots. See the
Commands and Reports section of this manual for a
description of the rtrv-eqpt: command format.
To Next Page
Loading...