363-206-305 Trouble Clearing:
TAP-116
Issue 3, June 2000 Page 3 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
12. Did SYSCTL fail, indicated by the following or similar SYSCTL CP failed
message?
ins-prog:
tid
DENY
SSTP
/*Status, execution stopped.*/
/*Installation cannot be done because of SYSCTL test
failure. */
If YES, proceed to Step 17.
If NO, continue with Step 13.
13. Did FAULT LED on SYSCTL light and did the SYSCTL FE ID display go off?
If YES, proceed to Step 19.
If NO, continue with Step 14.
14.
NOTE:
It is assumed that the program installation failed in one of two ways:
before the old program was erased or after the old program was erased.
If the program installation failed after 1 minute, the DDM-2000 may have
erased its old program and will be unable to report alarms or do
protection switches. If program installation failed within 1 minute, the old
program may not have been erased and the DDM-2000 may have
automatically reset and restarted its old program. A new attempt must be
made to install the program.
Check PC COM( ) port to CIT connection. Check PC disk drive and floppy
diskette.
To Next Page
Loading...