DLP-501
: Detailed Level Procedure 363-206-305
Page 4 of 6 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
8.
NOTE:
FiberReach compatible software must be installed in the
BBG8/BBG8B
SYSCTL
. When the new
SYSCTL
is installed, one of the following
indications will be displayed in the
FE ID
display. Displayed letters or
conditions indicate one of the following:
A. Nothing displayed in the
FE ID
display indicates that either Fiber-
Reach compatible software is installed in the
SYSCTL
or the
SYSCTL
contains software that is not compatible with the Fiber-
Reach shelf. If the
CR
LED did not start flashing in Step 6 and the
FE
ID
display is blank, the
SYSCTL
contains software not compatible
with the FiberReach shelf. New software must be loaded using the
procedures of
DLP-536
.
B. The letter
P
displayed in the
FE ID
display indicates that no software
is installed in the
SYSCTL
. If the
P
is followed by a period (
P.
), it
means that a previous download attempt has failed and a new soft-
ware download will have to be attempted locally using the
ins-prog:tid
command. If there is no period (
P
), the software can
only be downloaded locally.
C. The letter
U
displayed in the
FE ID
display indicates unsupported
SYSCTL
switch settings for the type of shelf being equipped.
Remove
SYSCTL
. Check option switch settings and repeat this pro-
cedure.
D. The letter
E
displayed in the
FE ID
display indicates that the
SYSCTL
must be replaced. Replace
SYSCTL
and repeat this procedure.
E. The letter
F
displayed in the
FE ID
display indicates that the
SYSCTL
faceplace latch is not fully latched. Latch the faceplate. (A reset
occurs after the faceplate is latched.)
F. A flashing letter
L
displayed in the
FE ID
display indicates a low volt-
age condition (brownout) on the shelf. Use
TAP-119
to clear brown-
out conditon.
Did the letter "
P
" appear in the
FE ID
display?
If
YES
, continue with
Step 9
.
If
NO
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE
.
To Next Page
Loading...