DLP-521
: Detailed Level Procedure 363-206-305
Page 2 of 4 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
5.
NOTE:
Security is available to protect against unauthorized access to the
system. System security requires the defaults for the privileged user
logins/password to be changed and CIT and/or DCC port security to be
enabled. If security is enabled on a port, users must enter a valid login
and password to access the system through that port.
NOTE:
The system always has three privileged user logins to minimize the
chance that both users will forget their passwords at the same time. You
must be logged into the system as a
privileged user
to set security; add,
change, or delete logins; and to execute some commands. The default
privileged user
logins (Release 2.1 and later) are LUC01 (upper case
LUC-zero-one), LUC02 (upper case LUC-zero-two), and LUC03 (upper
case LUC-zero-three). The default
privileged user
password is
DDM-2000. For Release 2.0 and earlier, the defaults for the privileged
user logins are ATT01 (upper case ATT-zero-one), ATT02 (upper case
ATT-zero-two), and ATT03 (upper case ATT-zero-three). The CIT login
banner for Release 2.0 and earlier reads: AT&T, DDM-2000
FiberReach, Release a.b.c.
Were you sent here from
DLP-500
to connect CIT?
If
YES
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If
NO
, continue with
Step 6
.
To Next Page
Loading...