Lucent Technologies FiberReach DDM-2000 - Page 1603

363-206-305 Detailed Level Procedure:
DLP-521
Issue 3, June 2000 Page 3 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
6. If security has been enabled, enter your login, and then enter your password
when prompted.
If security has not been enabled, enter a carriage RETURN.
Response: CIT prints the following message followed by an Alarm
and Status Report:
7.
NOTE:
The system prompt may be something other than < if there is an alarm
condition (for example, if there is an MJ alarm condition on the system,
the prompt will be MJ < ).
TID date time
M rtrv-alm: all COMPLD
/* Active Alarms and Status Report
Lucent Technologies
DDM-2000 FiberReach
Release a.b.c
**********************************
**********************************/
/
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
.
.
.