363-206-305 Detailed Level Procedure:
DLP-536
Issue 3, June 2000 Page 13 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
29. If the download
starts and fails
during its progress, exit term (Alt-F2) and then
restart a new term session.
30. Unplug and reseat the SYSCTL and immediately push and hold the FE SEL
and UPD/INIT buttons at the same time until a P appears in the FE ID display
(takes approximately 15 seconds).
If the download still does not complete, refer to Trouble Clearing: TAP-116.
31. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
32. Use the rtrv-alm: command to display alarm and status information.
33. Does status message dormant/exec code mismatch appear in the report
for this shelf?
If NO, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If YES, continue with Step 34.
34.
NOTE:
The software you downloaded has been loaded as a dormant copy in this
shelf. The original software is still the executing software. The apply:
command must be used at this shelf to install the dormant copy of
software as an executing copy. When the apply: command is executed
during an upgrade from Release 3.1 or later, if you do not specify a time
and date parameter, there is a default 15-minute delay before the
dormant copy installation begins. Once the installation begins, the
dormant copy is installed in approximately 10 minutes.
See the Commands and Reports section of Volume 1 of this manual for a
description of the apply: command. The apply: command allows you
to coordinate the software download across the network.
Are you going to use the apply: command at this time to install the dormant
version of software?
If YES, continue with Step 35.
If NO, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...