215651 124 Revision B
Every 250 Hours
Lubricate the following components every 250 hours unless otherwise stated.
NOTE:
Use High Temperature Extreme Pressure (EP2) Performance with 1% max molybdenum disulphide (NLGI Grade 2) lithium
base unless otherwise specified.
$
%
%
Figure 5.11: Every 250 Hours
A - Upper Cross Auger U-Joint
75
B - Upper Cross Auger Bearing (Two Places)
76
MAINTENANCE AND SERVICING
75. U-joint has an extended lubrication cross and bearing kit. Stop greasing when greasing becomes difficult or if U-joint
stops taking grease. Overgreasing will damage U-joint. Six to eight pumps are sufficient at first grease done at
(factory). Decrease grease interval as U-joint wears and requires more than six pumps.
76. Use High Temperature Extreme Pressure (EP2) Performance With 1.5– 5.0% molybdenum disulphide (NLGI Grade 2)
lithium base grease.
To Next Page
Loading...
