215651 241 Revision B
• If the tire is not correctly positioned on the rim or is overinflated, the tire bead can loosen on one side causing air to
escape at high speed and with great force. An air leak of this nature can thrust the tire in any direction endangering
anyone in the area.
• Make sure all the air is removed from the tire before removing the tire from the rim.
• Do NOT remove, install, or repair a tire on a rim unless you have the proper equipment and experience to perform
the job.
• Take the tire and rim to a qualified tire repair shop.
1. Check the tire pressure. Refer to Table 5.8, page 241.
2. Make sure the tire is correctly seated on the rim before inflating.
a. If the tire is not correctly positioned on the rim, take the tire to a qualified tire repair shop.
3. If inflation is required, use a clip-on chuck and an extension hose to inflate the tire to the desired pressure.
IMPORTANT:
Do NOT exceed maximum inflation pressure indicated on tire label or sidewall.
Table 5.8 Tire Pressure
Size
Load Range
Pressure
ST205/75 R15
D
517 kPa (75 psi)
ST205/75 R15
E
586 kPa (85 psi)
MAINTENANCE AND SERVICING
To Next Page
Loading...
