215651 47 Revision B
Table 3.2 Recommended D1X/D1XL Header Settings for Canola, Stubble Height 102–203 mm (4–8 in.)
Stabilizer
Wheels
3
Variable
Float N (lbf)
4
311–445 (70–100)
Crop Condition
Divider Rods
Header
Angle
5
Skid Shoe
Position
6
Reel Cam
7
Reel
Speed %
8
Knife Speed
9
Reel
Position
10
Upper Cross
Auger
Light
On 8–10
Variable
2
5–10
Medium
6or7
Not required
Normal
On 8–10
Middle
or Down
110
Low
6or7
Not required
Heavy
On 8–10
Variable
1
10 Low 3 or 4
Recommended
Lodged
On 8–10
Middle
or Down
25–10
Low
3or4
Recommended
OPERATION
3. Stabilizer wheels are used to limit the side-to-side movement when cutting off the ground in rolling terrain and to minimize bouncing.
4. Force required to lift header at ends. Refer to your windrower operator’s manual for adjustment procedures.
5. Set header angle as shallow as possible (setting A) with center-link and skid shoes while maintaining cutting height. Refer to 3.7.3 Header Angle, page 63.
6. Skid shoe position is used in combination with header angle to determine the cutting height when cutting on or very close to the ground. Refer to Adjusting
Skid Shoes, page 62.
7. Refer to Reel Cam Settings, page 68.
8. Percentage above ground speed.
9. Refer to 3.7.7 Knife Speed Information, page 66.
10. Refer to 3.7.9 Reel Fore-Aft Position, page 67.
To Next Page
Loading...
