MAN B&W 19.06
Page of
MAN Diesel
MAN B&W ME/MEC/MEGI engines 198 64 162.3
Cylinder cover, plate 901 and others
Cylinder cover with fuel, exhaust and starting
valves, indicator valve and sealing rings (disas-
sembled)
½ set Studs for cylinder cover
Piston, plate 902
Piston complete (with cooling pipe), piston rod,
piston rings and stufng box, studs and nuts
set Piston rings for cylinder
Cylinder liner, plate 903
Cylinder liner inclusive of sealing rings and
gaskets.
Cylinder lubricating oil system, plate 903
)
set Spares for lubricating oil system for cyl.
2 Lubricator backup cable
Connecting rod, and crosshead bearing, plate 904
Telescopic pipe with bushing for cylinder
Crankpin bearing shells in 2/2 with studs and nuts
Crosshead bearing shell lower part with studs
and nuts
2 Thrust pieces
Thrust block, plate 905
set Thrust pads for ‘ahead’
For NK also one set ‘astern’ if different from
‘ahead’
HPS Hydraulic Power Supply, plate 906
and 2
)
Proportional valve for hydraulic pumps
Leak indicator
Safety coupling for hydraulic pump
Accumulator
6 Chain links. Only for ABS, LR and NK
set Flex pipes, one of each size
Electric motor
Engine control system, plate 906
2
)
Multi Purpose Controller
Amplier for Auxiliary Control Unit
Position Amplier
Trigger sensor for tacho system, only if
trigger ring
Marker sensor for tacho system
Tacho signal amplier
IDkey
Encoder
Fuse kit
Starting valve, plate 907
Starting valve, complete
Solenoid valve
2
)
Hydraulic cylinder unit, plate 907
and 2
)
Fuel booster barrel, complete with plunger
FIVA valve complete
Suction valve complete
set Flex pipes, one of each size
High-pressure pipe kit
Packing kit
Exhaust valve, plate 908
2 Exhaust valves complete. only for GL
Highpressure pipe from actuator to exhaust valve
Exhaust valve position sensor
Fuel valve, plate 909
set Fuel valves for all cylinders on one engine for BV,
CCS, DNV, GL, KR, NK, RINA, RS and IACS
set Fuel valves for half the number of cylinders on
the engine for ABS
Highpressure pipe, from fuel oil pressure
booster to fuel valve
Turbocharger, plate 910
Set of maker’s standard spare parts
a) Spare rotor for one turbocharger, including
compressor wheel, rotor shaft with turbine
blades and partition wall, if any
Scavenge air blower, plate 910
set Rotor, rotor shaft, gear wheel or equivalent
working parts
set Bearings for electric motor
set Bearing for blower wheel
Belt, if applied
set Packing for blower wheel
Bedplate, plate 912
Main bearing shell in 2/2 of each size
set Studs and nuts for main bearing
) MD required spare parts.
2
)
All spare parts are requested by all Classes.
a) Only required for RS. To be ordered separately as
option: 4 87 660 for other classication societies.
Please note: Plate number refers to Instruction Book,
Vol. III containing plates with spare parts
List of Spare Parts, Unrestricted Service
Fig. 19.06.01: List of spare parts, unrestricted service: 4 87 601
Spare parts are requested by the following Classes
only: GL, KR, NK and RS, while just recommended by:
ABS, DNV and LR, but neither requested nor recom-
mended by: BV, CCS and RINA.
To Next Page
Loading...
Need help?
General