Micom P634 - Page 371

Parameter Address
Default Min Max Unit Logic Diagram
“Logical”
communication
interface 1
COMM1: Function group COMM1
056 026
0: Without
[spacer]
Cancelling function group COMM1 or including it in the configuration. If the
function group is cancelled from the configuration, then all associated settings
and signals are hidden, with the exception of this setting.
[spacer]
COMM1: General enable USER
003 170
0: No Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
Disabling or enabling communication interface 1.
[spacer]
COMM1: Basic IEC870-5 enabl
003 215
0: No Fig. 3-6, (p. 3-11)
[spacer]
Common settings for enabling all protocols based on IEC 870-5-xxx.
[spacer]
COMM1: Addit. -101 enable
003 216
0: No Fig. 3-6, (p. 3-11)
[spacer]
Enabling additional settings that are relevant for the protocol based on
IEC 870-5-101.
[spacer]
COMM1: Addit. ILS enable
003 217
0: No Fig. 3-6, (p. 3-11)
[spacer]
Enabling additional settings that are relevant for the ILS protocol.
[spacer]
COMM1: MODBUS enable
003 220
0: No Fig. 3-6, (p. 3-11)
[spacer]
Enabling settings relevant for the MODBUS protocol.
[spacer]
COMM1: DNP3 enable
003 231
0: No Fig. 3-6, (p. 3-11)
[spacer]
Enabling settings relevant for the DNP 3.0 protocol.
[spacer]
COMM1: COURIER enable
103 040
0: No Fig. 3-6, (p. 3-11)
[spacer]
Enabling settings relevant for the COURIER protocol.
[spacer]
COMM1: Communicat. protocol
003 167
060 000: MAIN: Without function Fig. 3-6, (p. 3-11)
[spacer]
Select the communication protocol that shall be used for the communication
interface.
7 Settings P634
P634/EN M/R-42-A // P634‑311‑653 7-17