Micom P634 - Page 542

Parameter Address
Default Min Max Unit Logic Diagram
Main function
MAIN: Date
003 090
1997-01-01 1997-01
-01
2098-11
-08
dd.mm.yy Fig. 3-64, (p. 3-95)
[spacer]
Date display. The date can also be set here. The centuries are not displayed.
The supported dates range from January 1st, 1997, until November 7th, 2098.
[spacer]
MAIN: Time of day
003 091
00:00:00 00:00:00 24:00:00 hh:mm:ss Fig. 3-64, (p. 3-95)
[spacer]
Display of the time of day. The time can also be set here.
[spacer]
MAIN: Time switching
003 095
0: Standard time Fig. 3-64, (p. 3-95)
[spacer]
Setting for standard time or daylight saving time.
This setting is necessary in order to avoid misinterpretation of the times
assigned to signals and event data that can be read out through the PC or
communication interfaces.
[spacer]
MAIN: Frequency f
004 040
Not measured 40.00 70.00 Hz Fig. 3-51, (p. 3-82)
[spacer]
Display of system frequency.
[spacer]
MAIN: Curr. IP,max,a prim.
005 101
Not measured 0 65000 A Fig. 3-46, (p. 3-78)
[spacer]
Display of the maximum phase current as a primary quantity, end a.
[spacer]
MAIN: IP,max prim.,delay a
005 162
Not measured 0 65000 A Fig. 3-46, (p. 3-78)
[spacer]
Display of the delayed maximum current of end a as a primary quantity.
[spacer]
MAIN: IP,max prim.stored a
005 161
Not measured 0 65000 A Fig. 3-46, (p. 3-78)
[spacer]
Display of the delayed stored maximum phase current of end a as a primary
quantity.
[spacer]
MAIN: Curr. IP,max,b prim.
005 102
Not measured 0 65000 A
[spacer]
Display of the maximum phase current as a primary quantity, end b.
[spacer]
MAIN: IP,max prim.,delay b
006 162
Not measured 0 65000 A
[spacer]
Display of the delayed maximum current of end b as a primary quantity.
P634 8 Information and Control Functions
8-4 P634/EN M/R-42-A // P634‑311‑653