Page 110
Liability for Material Defects
optoNCDT 2300
13. Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if defects occur despite our care-
ful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery.
Within this period, defective parts, except for wearing parts, will be repaired or replaced free of charge, if the device is returned to MI-
CRO-EPSILON with shipping costs prepaid. Any damage that is caused by improper handling, the use of force or by repairs or modifi-
cations by third parties is not covered by the liability for material defects. Repairs are carried out exclusively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular, MICRO-EPSILON shall
not be liable for any consequential, special, indirect or incidental damage. In the interest of further development, MICRO-EPSILON
reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
14. Decommissioning, Disposal
Remove the power supply and output cable from the sensor.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging materials in compliance with the applicable
country-specific waste treatment and disposal regulations of the region of use.
To Next Page
Loading...
