Page 64
Control Menu, Set Sensor Parameter
optoNCDT 2300
7.4.4.3 Statistical values
The optoNCDT 2300 can deduce the following statistical values from the result of measuring or the calculating:
MIN Minimum
Signal
Evaluation cycle
Maximum
Minimum
Time
Peak-to-peak
Peak-to-peak
in evaluation cycle
MAX Maximum
PEAK2PEAK
Peak-to-peak value
(Range)
Fig. 35 Statistical values and evaluation cycle
The statistical values are calculated from the measurement values within the evaluation cycle. With the command RESET STATISTICS,
a new evaluation cycle (storage period) will be initiated. At the beginning of a new cycle, the old statistical values are deleted.
To Next Page
Loading...
