MICRO-EPSILON optoNCDT 2300 - Input and Outputs

Page 41
Installation
optoNCDT 2300
5.6.4 Input and Outputs
Signal
Designation
Sensor Pin
14-pin ODU
Comment
Cable PC2300-x/SUB-D
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Fig. 21 Sensor round pin
plug, view: Solder-pin side
male cable connector,
insulator
15-pin Sub-D
+ U
B
1 Supply voltage (11 ... 30 VDC) 1
Ground 2
System ground for supply and
ground potential for RS422-level
9
+Laser on/off
3
Optocoupler input, potential-free
Laser off: U
E
≤0,8V(Low)
Laseron:2,8V≤U
E
≤30V(High)
2
- Laser on/off
4 10
Sync-in/out
2
5
Synchronous- respectively trigger signals,
symmetrically, RS422-Pegel, terminating resis-
tor 120 Ohm switchable, input or output select-
ed depending on the synchronization mode
3
/Sync-in/out
2
6 11
RxD-RS422 7
Serial input RS422, symmetrically,
Internally terminated with 120 Ohm
4
/RxD-RS422 8 12
TxD-RS422 9
Serial output RS422, symmetrically
5
/TxD-RS422 10 13
Tx - Ethernet 11
Ethernet output, potential-free
6
/Tx - Ethernet 12 14
Rx - Ethernet 13
Ethernet input, potential-free
7
/Rx - Ethernet 14 15
Screen Housing No galvanic connection to ground Housing
1) You will find more cables in appendix.
2) In trigger operation, see Chap. 7.6.1, the input is used for triggering.
Plug connector: ODU MINI-SNAP, 14-pol., series B, dimension 2, code F, IP 68.