MICRO-EPSILON optoNCDT 2300 - A 6.6 Example Command Sequence During Measurement Selection

Page 144
Appendix| ASCII Communication with Sensor
optoNCDT 2300
A 6.6 Example Command Sequence During Measurement Selection
RS422 interface Ethernet interface Content
MEASMODE Selection: diffuse or direct refection, displacement or thickness measurement,
video signal or measurement output
MEASPEAK Peak selection for displacement measurement
MEASRATE Measuring rate (under consideration of reflectivity and movement of the target)
VSAVERAGE Averaging of the video signal (under consideration of reflectivity structure and
movement of the target)
AVERAGE Averaging ot the measurements (under consideration of reflectivity structure and
movement of the target)
OUTPUT Selection of the output channel
OUTREDUCE Reduction of the output data rate (under consideration of the selected output
channel/channel settings and processing bandwidth of the target system)
OUTHOLD Output characteristic during measurement errors
OUTDIST_RS422 Selection of the displacement values to be output through the RS422 interface
Selection is automatically determined by „MEASMODE“ and „MEASPEAK“ for
the Ethernet interface
OUTTHICK_RS422 Selection of thickness output through RS422 interface
Selection is automatically determined by „MEASMODE“ for the Ethernet interface
OUTSTATISTIC_RS422 OUTSTATISTIC_ETH Selection of the statistic values to be output
OUTADD_RS422 OUTADD_ETH Selection of the optional values to be output
IPCONFIG Ethernet interface settings
MEASTRANSFER Settings for data output through Ethernet interface
BAUDRATE Baud rate settings for RS422 interface