Page 12
Safety
optoNCDT 2300
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the sensor
Protect the sensor cable against damage.
> Destruction of the sensor
> Failure of the measuring device
Avoid continuous exposure to fluids on the sensor.
> Damage to or destruction of the sensor
Avoid exposure to aggressive materials (washing agent, penetrating liquids or similar) on the sensor.
> Damage to or destruction of the sensor
1.3 Notes on CE Marking
The following apply to the optoNCDT 2300:
- EU directive 2014/30/EU
- EU directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and the relevant applicable harmonized Euro-
pean standards (EN). The measuring system is designed for use in industrial environments.
The EU Declaration of Conformity and the technical documentation are available to the responsible authorities according to the EU
Directives 7.
1.4 Intended Use
- The optoNCDT 2300 system is designed for use in industrial and laboratory areas.
- It is used
for measuring displacement, distance, position and elongation
for in-process quality control and dimensional testing
- The sensor must only be operated within the limits specified in the technical data, see Chap. 3.4.
- The sensor must be used in such a way that no persons are endangered or machines and other material goods are damaged in
the event of malfunction or total failure of the controller.
- Take additional precautions for safety and damage prevention in case of safety-related applications.
To Next Page
Loading...
