MICRO-EPSILON optoNCDT 2300 - A 6.5.2.4 Data Selection Statistic Values; A 6.5.2.5 Data Selection Optional Values; A 6.5.2.6 Set Video Output

Page 143
Appendix| ASCII Communication with Sensor
optoNCDT 2300
A 6.5.2.4 Data Selection Statistic Values
OUTSTATISTIC_ETH NONE|([MIN] [MAX] [PEAK2PEAK])
OUTSTATISTIC_RS422 NONE|([MIN] [MAX] [PEAK2PEAK])
- NONE: No output of statistic values
- MIN: Output of the minimum
- MAX: Output of the maximum
- PEAK2PEAK: Output of peak to peak values
A 6.5.2.5 Data Selection Optional Values
OUTADD_ETH NONE|([SHUTTER][COUNTER] [TIMESTAMP] [INTENSITY] [STATE] [TRIGCNT] [TEMP])
OUTADD_RS422 NONE|([TEMP] [SHUTTER] [COUNTER] [TIMESTAMP] [INTENSITY] [STATE])
Defines the optional values to be transmitted.
- NONE: No output of further values
- SHUTTER: Output of the exposure time
- COUNTER: Output of the profile counter
- TIMESTAMP: Output of the time stamp
- INTENSITY: Parallel output of intensity and displacement
- STATE: Output of the state word
- TRIGCNT: Output trigger counter (with Ethernet only)
- TEMP: Output of the temperature in 0.25°C increments
Via Ethernet, more optional values can be out parallel.
A 6.5.2.6 Set Video Output
OUTVIDEO NONE|[RAW] [CORR]
Defines the the video data to be transmitted through Ethernet.
- NONE: No video signal
- RAW: Output of the unconditioned signal
- CORR: Output of the corrected signal