Page 77
Control Menu, Set Sensor Parameter
optoNCDT 2300
The counter starts with 0. It follows:
number of trigger events = trigger event counter + 1.
An overflow occurs after 16384 trigger events, and the counter will start again at 0, where T= 1.
7.6.2.4 Trigger Measurement Value Counter
The trigger measurement value counter is reset at each trigger edge (preset) and counts the number of measurement values within
each trigger event. It follows:
- for level triggers: number of measurement values within the selected trigger level
- for edge triggers: from the selected trigger edge for the selected number of measurement values
- for software triggers: after completing the command for the selected number of measurement values
The counter has a bit width of 14 bit which are the lower 14 bits of the counter’s low part.
Counting range: 0 ... 16383
The counter starts with 0.
It follows:
number of measurement values during a trigger event = trigger measurement value counter + 1.
7.6.2.5 Example
If the number of the measuring values per trigger event is set with TRIGGERCOUNT at e.g. 10, see Chap. A 6.3.3.4, so TRIGGVAL-
UECNT would count from 0 to 9.
To Next Page
Loading...
