Page 47
Operation
optoNCDT 2300
6.2.2 Access via Ethernet
Once the sensor is provided with an IP address, which is valid for your environment and it is known to you, you can connect the sen-
sor with a web browser, see Chap. 6.2.1.
Interactive websites for programming the sensor now appear in the web browser.
The parallel operation using a Web browser and ASCII commands is possible; the last setting applies. Remember to save the settings.
Programming the sensor. In the top navigation
bar other auxiliary functions (settings, video
signal, etc.) are available. All settings in the
website will be immediately executed in the
sensor after pressing the button Apply.
Fig. 24 First interactive website after selection
of the IP address.
The look of the website may change depending on the features. Each page contains descriptions of the parameters and so tips for
filling out the web site.
To Next Page
Loading...
