Page 48
Operation
optoNCDT 2300
Further sub-menus, such as measuring rate and triggering, are avail-
able via the left navigation of the website.
i
After programming all the settings are to be stored permanently
in a set of parameters. The next time you turn on the sensor
they are available again.
6.2.3 Measurement Presentation via Web Browser
For graphical description of the measuring results “Java“ must be enabled and updated in the browser.
Start the measurement value display (Measurement) in the horizontal navigation bar.
Fig. 25 Web interface
i
If you leave the diagram display in a separate tab or window of the browser running, you do not have to restart the description
each time.
Click the button Start, for starting the display of the measurement results.
The demo can only be started, if a possible saving of measured values is completed via Ethernet, because only one of two features
can be active via Ethernet.
To Next Page
Loading...
