Page 123
Appendix| ASCII Communication with Sensor
optoNCDT 2300
A 6.2 Commands Overview
Group Chapter Command Short info
General
Chap. A 6.3.1.2 GETINFO Sensor information
Chap. A 6.3.1.3 SYNC Synchronization
Chap. A 6.3.1.4 RESET Booting the sensor
Chap. A 6.3.1.5 RESETCNT Reset counter
Chap. A 6.3.1.5 ECHO Switching the Command Reply, ASCII Interface
Chap. A 6.3.1.7 PRINT Print
User level
Chap. A 6.3.2.1 LOGIN Change of user level
Chap. A 6.3.2.2 LOGOUT Change to user in the user level
Chap. A 6.3.2.3 GETUSERLEVEL User level request
Chap. A 6.3.2.4 STDUSER Set standard user
Chap. A 6.3.2.5 PASSWD Change password
Triggering
Chap. A 6.3.3.1 TRIGGER Trigger selection
Chap. A 6.3.3.2 TRIGGERAT Effect of the Trigger Input
Chap. A 6.3.3.3 TRIGGERLEVEL Trigger level
Chap. A 6.3.3.4 TRIGGERCOUNT Number of measurement values displayed
Chap. A 6.3.3.5 TRIGGERSW Software - Trigger pulse
Chap. A 6.3.3.6 TRIGGEROUT Selection of output values with triggering
To Next Page
Loading...
