Page 135
Appendix| ASCII Communication with Sensor
optoNCDT 2300
A 6.3.4.4 Change between Ethernet / EtherCAT
ETHERMODE ETHERNET|ETHERCAT
Switches between Ethernet and EtherCat.
A 6.3.4.5 Units Web-Interface
UNIT MM|INCH
Change the measurement display on the web pages. The command has no effect on the ASCII interface.
- MM representation in mm
- INCH representation in customs
A 6.3.5 Load / Save Settings
A 6.3.5.1 Save Parameter
STORE 1|2|3|4|5|6|7|8
Stores current parameters of internal sensor RAM into the chosen number of internal sensor flash.
A 6.3.5.2 Load Parameter
READ ALL|DEVICE|MEAS 1|2|3|4|5|6|7|8
Loads parameter into internal sensor RAM from the chosen number of internal sensor flash. In addition, the size of the loaded data
needs to be specified.
- ALL: All parameters are loaded.
- DEVICE: Only the standard device settings are loaded (interface parameter)
- MEAS: Only the measurement settings are loaded (all features for the measurement)
A 6.3.5.3 Default Settings
SETDEFAULT ALL|NODEVICE|MATERIAL
Sets sensor back to default settings.
- ALL: All setups are deleted and default parameters are loaded. In addition, the current material table is overwritten by standard
material table.
- NODEVICE: All setups are deleted and default parameters are loaded. Settings of IP address and RS422 are kept temporarily.
- MATERIAL: Current material table is overwritten by standard material table.
To Next Page
Loading...
