Page 66
Control Menu, Set Sensor Parameter
optoNCDT 2300
7.4.6 Material Data Base
You can save the optical refractive indices of various materials in the sensor, that can be used for the measurement of direct reflection.
The material database of the condition at delivery can be recovered by loading the factory settings. Up to 20 materials can be stored
in the material database.
Material name Value General information on material
Material description Value
Refractive index n Value Optical refractive index of material
optoNCDT
ERR
Power on
RUN
EtherCAT Ethernet
Laser off
In range
Midrange
Error
LASER RADIATION
Do not stare into beam
Class 2 Laser Product
IEC 60825-1: 20xx-xx
P 1mW; P 1.2mW; t=0.5...542 s
0 P
≤ ≤ μ
F=1.5...50kHz;
=670nm
For measurements on transparent targets, such as films, it is due to the refractive
index to smaller measurement values than it is actually the case.
Is the respective material specified now for the measurement, the refractive index
runs into the calculation and so the sensor delivers the correct result.
Grey shaded fields require a selection.
Value
Dark-bordered fields require you to specify a value.
To Next Page
Loading...
