Page 27
Installation
optoNCDT 2300
5. Installation
5.1 General
The optoNCDT 2300 sensor is an optical system for measurements with micrometer accuracy.
The optoNCDT 2300 can be operated in direct or diffuse reflection.
i
Make sure it is handled carefully when installing and operating.
optoNCDT
ERR
Power on
RUN
EtherCAT Ethernet
Laser off
In range
Midrange
Error
optoNCDT
ERR
Power on
RUN
EtherCAT Ethernet
Laser off
In range
Midrange
Error
Laserstrahlung
Nicht in den Strahl blicken
Laser Klasse 2
nach DIN EN 60825-1: 20xx-xx
P 1mW; P 1,2mW; t=0,5...542 s
0 P
≤ ≤ μ
F=1,5...50kHz;
=670nm
Laserstrahlung
Nicht in den Strahl blicken
Laser Klasse 2
nach DIN EN 60825-1: 20xx-xx
P 1mW; P 1,2mW; t=0,5...542 s
0 P
≤ ≤ μ
F=1,5...50kHz;
=670nm
P
A
Er
P 1mW; P 1,2mW; t=0,5...542 s
0 P
≤ ≤ μ
F=1,5...50kHz; =405nm
Diffuse reflection Direct reflection
approx. 315 (12.4)
48.5 (1.91)
ø16
(.63 dia.)
Fig. 5 Distinction sensor assembly in diffuse and direct reflection Fig. 6 Dimensional drawing sensor cable
i
Mount the sensor only to the existing through-holes on a flat surface. Clamps of any kind are not permitted. Do not exceed
torques.
To align the sensor, please comply with the “Instructions for Operation“, see Chap. 10.3, especially.
If the sensors are to be used in soiled environments or in higher ambient temperatures than normal, MICRO-EPSILON recommends
the use of protective housings, see Chap. 10.5.
The suggested free space in the tuning range, see Fig. 8, is kept clear at least until the end of the measuring range of foreign material
and ambient light of other laser sensors.
To Next Page
Loading...
