Page 83
Control Menu, Set Sensor Parameter
optoNCDT 2300
i
After programming all the settings are to be saved permanently as a set of parameters, so the next time you turn on the sensor
they are available again.
If the settings under the selected parameter set no. are saved in the sensor, it works with the new values after the loading process. It is
therefore not a new boot process in the sensor performed. The parameter-set which was saved last will be loaded when the sensor is
switched on.
7.7.2 Extras
Language German / English Language of the interactive websides.
Unit mm / inch Units in the measurement representation
Factory settings Only reset the material data base Checkbox Allows to replace only the values in the material data-
base.
Interface settings maintained Checkbox This enables to leave all the settings for the Ethernet
and the RS422 interface unchanged.
Grey shaded fields require a selection.
Value
Dark-bordered fields require you to specify a value.
To Next Page
Loading...
