MICRO-EPSILON optoNCDT 2300 - Presets for Trigger Mode and Trigger Edge

Page 79
Control Menu, Set Sensor Parameter
optoNCDT 2300
7.6.2.7 Presets for Trigger Mode and Trigger Edge
The preset values for trigger mode and trigger edge are applied from the selections in the web interface Settings > Trigger
mode. They can also be specified using the TRIGGER,TRIGGERLEVEL, TRIGGERCOUNT commands.
The following edge comes into effect after selecting the trigger counter:
Trigger mode Trigger acts on Effective trigger edge
Level triggering
low level high / low
high level low / high
Edge triggering
falling edge high / low
rising edge low / high
Software triggering after execution of the command (no time reference)