Page 53
Control Menu, Set Sensor Parameter
optoNCDT 2300
7. Control Menu, Set Sensor Parameter
7.1 Preliminary Remarks to the Adjustments
You can program the optoNCDT 2300 simultaneously in two different ways:
- using a web browser via the sensor Web interface
- ASCII command set and a terminal program via RS422 or Ethernet (Telnet). Received measurement values are displayed with
binary character.
i
If you do not save the programming permanently in the sensor, you lost the settings after turning off the sensor.
7.2 Overview Parameter
The following parameters can be set or change in the optoNCDT 2300, see Fig. 25 menu Settings.
Login Entering a password, change user level
Default settings Measurement program, measurement frequency, averaging, behav-
ior in the case of error, setting zero/setting masters and material data
base for thickness measurement
Data output Selection and setting of digital interface, data to be emitted, under-
scanning
Measurement control Triggering, synchronization of sensors
Parameter, extras Loading/saving parameter- and interface settings
Menu language, factory setting
7.3 Login, Change User Level
The assignment of a password prevents unauthorized changing of settings on the sensor. When delivered, the password protection
is not enabled. The sensor operates in the user level “expert“. The password protection should be enabled after configuration of the
sensor. The default password for the expert level is “000“.
i
The default password or a user-defined password is not changed by a software update. The expert password is independent of
the setup and is therefore not together loaded or saved with the setup.
To Next Page
Loading...
