Page 54
Control Menu, Set Sensor Parameter
optoNCDT 2300
The following functions are available for the user:
User Expert
Password required no yes
Looking settings yes yes
Changing settings, changing password no yes
Measurement value, looking video signal yes
1
yes
Scaling diagrams yes yes
Setting factory setting no yes
Fig. 29 Rights in the user hierarchy
Login
Login
You are currently logged in as User.
Password
Type the default password “000“ or a user-defined password in the
Password field and confirm with login.
Change with a click on the Logout button in the mode user.
Fig. 30 Change in the expert user level
The user management allows you to assign a custom password in the “expert“ mode.
Password Value Case-sensitive rules are observed for all passwords. Numbers are allowed. Special characters
are not allowed.
User level when
switching on
User /
Expert
Specifies the user level, with which the sensor starts after the re-starting. For this purpose,
MICRO-EPSILON recommends the selection user.
1) Only if there is no measurement output via a different interface. Otherwise you must be logged in expert mode.
Grey shaded fields require a selection.
Value
Dark-bordered fields require you to specify a value.
To Next Page
Loading...
