Page 14
Laser Class
optoNCDT 2300
2. Laser Class
The optoNCDT 2300 sensors operate with a semiconductor laser with a wavelength of 670 nm (visible/red ILD2300-x) resp. 405 nm
(visible/blue ILD2300-xBL). The sensors fall within Laser Class 2 (II). The laser is operated on a pulsed mode, the average power is
≤1mWineachcase,thepeakpowercanbeupto1.2mW.Thepulsefrequencydependsontheadjustedmeasuringrate/1.5...
49.140 kHz). The pulse duration of the peaks is regulated depending on the measuring rate and reflectivity of the target and can be
0.5 up to 542 µs.
Laser radiation. Close your eyes or immediately turn away if the laser beam hits the eye. Irritation or injury of the
eyes possible.
i
Observe the laser protection regulations!
Although the laser output is low looking directly into the laser beam must be avoided. Due to the visible light beam eye protection is
ensured by the natural blink reflex. The housing of the optical sensors may only be opened by the manufacturer, see Chap. 13. For
repair and service purposes the sensors must always be sent to the manufacturer.
The following warning labels are attached to the cover (front and/or rear side) of the sensor housing. The laser warning labels for
Germany have already been applied (see above). Those for other non German-speaking countries an IEC standard label is included
in delivery and the versions applicable to the user’s country must be applied before the equipment is used for the first time. Laser
operation is indicated by LED, see Chap. 3.5.
LASER RADIATION
Do not stare into beam
Class 2 Laser Product
IEC 60825-1: 2014
P 1mW; P 1.2mW; t=0.5...542 s
0 P
≤ ≤ μ
F=1.5...50kHz;
=670nm
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR CONFORMANCE WITH
IEC 60825-1 ED. 3., AS DESCRIBED IN
LASER NOTICE NO. 56, DATED MAY 8, 2019
IEC label Only for USA
To Next Page
Loading...
