Page 46
Operation
optoNCDT 2300
Direct connection to PC, sensor with static IP (Factory setting) Network
PC with static IP PC with DHCP Sensor with dynamic IP, PC with DHCP
Connect the sensor to a PC via a direct Ethernet connection (LAN). Use an
optionally available cable PC2300-x and PC2300-0.5/Y.
Connect the sensor to a switch (Intranet).
Use an optional available cable PC2300-x
and PC2300-0.5/Y.
Now start the SensorTool.exe program.
Click the button Sensor. Select the
designated sensor from the list. In order
to change the address settings, click the
button Change IP-Address.
• Address type: static IP address
• IP address: 169.254.168.150
1
• Subnet mask: 255.255.0.0
Click the button Change, to transmit the
changes to the sensor.
Click the button Open website to
connect the sensor with your default
browser.
1) Requires that the LAN connection on the
PC uses, for example, the following IP ad-
dress: 169.254.168.1.
Wait until Windows has estab-
lished a network connection (Con-
nection with limited connectivity).
Now start the
SensorTool.exe program.
Click the button Sensor.
Select the designated sensor
from the list.
Click the button Open
website button to connect
the sensor with your default
browser.
Enter the sensor in the DHCP / register the
sensor in your IT department.
The sensor gets assigned an IP address from your
DHCP server. You can check this IP address with
the SensorTool.exe program.
Now start the SensorTool.exe program.
Click the button Sensor. Select the desig-
nated sensor from the list.
Click the button Open website, to connect
the sensor with your default browser.
Alternatively: If DHCP is enabled and the DHCP
server is linked with the DNS server, an access is
possible on „ILD2300_SN01234567“ („01234567“
Serial number of your sensor)
Start a web browser on your PC. Type
„ILD2300_Serial number“ in the address bar
of your web browser.
You will find the latest program version of SensorTool at:
www.micro-epsilon.com/service/download/
To Next Page
Loading...
