Page 147
Appendix| ASCII Communication with Sensor
optoNCDT 2300
Error message Description
E37 ROI left must be lower than right. The value of the left side of ROI must be lower than the right value.
E38 Too much output values for RS422 enabled. Too much output values for RS422 enabled.
E39 not used
E40 It is not possibility to use UDP/IP for measure-
ment-server.
It is not possibility to use UDP/IP for measurement-server.
E41 The repeated input of new password is not the
same.
Password and verification password do not match.
E42 not used
E43 Triggermode SOFTWARE disabled. Software trigger is disabled.
E44 Material table is full. Material table is full.
E45 No video signal now No video signal now
E46 Unsupported character An unsupported character was received.
E47 The selection of signals is denied in current mea-
surement mode
The signal selection may not be changed in this measurement setup.
E48 Materialtable is empty Material table is empty.
E49 Software triggering is not active
Software triggering is not enabled, no software trigger pulse can be trig-
gered.
E50 The number and length of the objects to be
mapped would exceed PDO length
E51 Not exacly one measuring value for RS422 en-
abled (C-Box)
No or more measurements are enabled for RS422 aktiviert (C-Box)
E52 User level not available for this sensor Please contact Micro-Epsilon
To Next Page
Loading...
