Page 165
Appendix| EtherCAT
optoNCDT 2300
Error handling:
0 – Output of error value
1 – Hold last valid value for a number of measurement values (Number of held values: 0….1024,
0 = infinite)
Use spike correction
0 - without spike correction
1 - with spike correction
Spike correction evaluation length: Number of evaluated values (1 ... 10)
Spike correction range: Max. tolerance range in mm (0.0000000 ... 100.0000000)
Spike correction count: Number of corrected values (1 ... 100)
Reset counter:
- Bit 0: Reset time stamp counter
- Bit 1: Reset measured value counter
- Bit 2: Reset trigger counter
Resetting the individual counter is done by setting the corresponding bit to 1.
To Next Page
Loading...
