Page 199
Appendix| Control Menu
optoNCDT 2300
Digital interfaces
Selection of
digital interfaces
Web diagram / Ethernet measurement trans-
mission / RS422
Decides via the used interface for measurement
output. A parallel measurement output via mul-
tiple channels is not possible.
Data selection
Distance 1, 2 / Difference 1 to 2 / Statistics
Min / Statistics Max / Statistics peak-to-peak /
Exposure time / Intensity of distance value /
Status / Measurement value counter / Time
stamp / Trigger counter / Temperature
The data which are provided for the transmis-
sion are to activate with the checkbox.
Ethernet settings
IP settings basic unit
Address type Static IP address / DHCP
IP address Value
Values for IP address /
Gateway / Subnet mask.
For static IP address only.
Gateway Value
Subnet mask Value
Settings of Ethernet
measurement trans-
mission
Transmission type
Server TCP IP / Client TCP IP / Client UDP IP /
no transfer
IP address Value
for Client TCP IP and Cli-
ent UDP IP only
Port Value
RS422 settings Baud rate
9.6 / 115.2 / 230.4 / 460.8 / 691.2 / 921.6 / 1500
/ 2000 / 2500 / 3000 / 3500 / 4000 kBps
Ethernet/Ether-
CAT
Operation mode after start Ethernet / EtherCAT
Output data rate
Every measured
value
Value
Only every nth measurement value is output (n =
1, 2 ... 3.000.000). The other values are rejected.
Reduction inter-
faces
RS422 / Ethernet
The interfaces, which are provided for the sub-
sampling, are to be selected with the checkbox.
To Next Page
Loading...
