5 - 28
5.6 Network Settings for 1:1 Connection
5
SETTINGS AND PROCEDURES BEFORE OPERATION
(5) Changing the IP address of the C Controller module
Perform the following to change the IP address of the C Controller module from the
default IP (192.168.3.3).
(a) Displaying the relevant screen
From the <<Online operation>> tab of the C Controller setting utility, click the
button and select the <<IP address>> tab.
(b) Setting the IP address
Change the IP address (and Subnet mask, Default gateway if necessary), and
click the [Setting] button.
After setting, reset the C Controller module to update the IP address setting.
Figure 5.30 <<Online operation>> tab
Figure 5.31 IP address setting
Detail
To Next Page
Loading...
