Mitsubishi MELSEC Q Series - Page 192

5 - 44
5.8 Installing/Removing CompactFlash Card and Access Stop
5.8.1 Installing/removing CompactFlash card
5
SETTINGS AND PROCEDURES BEFORE OPERATION
(1) Installing the CompactFlash card
(a) Removing the dummy CompactFlash card
Open the front cover of the C Controller module, and remove the dummy
CompactFlash card.
1) Put your finger on the bottom of the C Controller module's front cover, and
open the front cover.
2) Press the EJECT button to remove the dummy CompactFlash card.
Remark
When having difficulty in replacing the CompactFlash card, the following tweezers
are available.
Product: Plastic tweezers
Model name: NK-2539
Figure 5.39 Removal of dummy CompactFlash card
Figure 5.40 Replacing the CompactFlash card using Plastic tweezers
MODE
ERR.
USER
RUN
CF CARD
CH2 SD/RD
-V-H01
Q06CCPU
PULL
100
M
RD
SD/
10BASE-T/
100BASE-TX
CH1
CF CARD
CH2
RS-232
Front cover
1) Open the front cover.
CompactFlash card slot
EJECT button
2) Press the
EJECT button.
Dummy CompactFlash card