FUEL SUPPLY ± Fuel Tank
13B-3
INSTALLATION SERVICE POINT
A SUCTION TUBE/HIGH PRESSURE TUBE
CONNECTION
Caution
After the connection, pull the high pressure tube and
suction tube gently in the direction of removal to check
that they are firmly connected.
INSPECTION
FUEL PUMP MODULE/PIPE AND GAUGE ASSEMBLY
REPLACEMENT
1. Remove the rear seat cushion.
2. Remove the service hole cover.
3. Disconnect the harness connector, fuel hose and tube.
4. Unscrew the mounting nuts, and then remove the pipe
and gauge assembly and fuel pump module.
5. Install the pipe and gauge assembly and fuel pump module.
Tighten the mounting nuts to the specified torque.
Specified torque: 2 ± 3 Nm
6. Connect the fuel hose, fuel tube and harness connector.
Caution
After the connection, pull the high pressure tube and
suction tube gently in the direction of removal to check
that they are firmly connected.
7. Install the service hole cover.
8. Install the rear seat cushion.
FUEL GAUGE UNIT CHECK
Refer to GROUP 54 ± Combination Meter.
Fuel tube
Harness
connector
Pipe and
gauge
assembly
Fuel tube
Fuel hose
Fuel tube
Harness
connector
Fuel hose
Fuel pump
module
To Next Page
Loading...
