INTAKE AND EXHAUST ± Intake Manifold
15-4
INTAKE MANIFOLD
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D Engine Coolant Draining and Supplying
(Refer to GROUP 14 ± On-vehicle Service.)
D Engine Cover and Under Cover Removal and
Installation
D Resonance Tank Removal and Installation
(Refer to P.15-3.)
D Ignition Coil Removal and Installation
(Refer to GROUP 16.)
D Throttle Body Removal and Installation
(Refer to GROUP 13A.)
1
2
3
4
5
27 ± 34 Nm
24 Nm
20 Nm
13
6
15
20
7
12
8
18
10
14
34 Nm
9 Nm
9
34 Nm
16
17
11
28 Nm
19 Nm
11
10 ± 12 Nm
19
21
10 ± 12 Nm
10 ± 12 Nm
10 ± 12 Nm
Removal steps
1. Engine coolant temperature sensor
connector connection
2. Condenser connector connection
3. Camshaft position sensor connector
connection
4. Injector harness connector connection
5. Purge control solenoid connector
connection
6. EGR valve connector connection
7. Harness connector bracket
8. Water hose and pipe
9. Brake booster vacuum hose
10. PCV hose connection
11. Vacuum hose connection
12. Fuel hose clamp
13. Intake manifold stay
14. A/T fluid level gauge guide
15. Front exhaust pipe connection
AA" 16. Fuel pump protector
17. EGR valve support connection
18. Gasket
19. Branch tube
20. Intake manifold assembly
21. Intake manifold gasket
To Next Page
Loading...
