Mitsubishi Pajero Pinin 1999 - Page 25

GENERAL ± Supplemental Restraint System (SRS)
00-23
5. Do not attempt to repair the wiring harness connectors
of the SRS. If the connector(s) are diagnosed as defective,
replace the wiring harness(es). If the harness(es) are
diagnosed as faulty, replace or repair the wiring
harness(es) according to the table that follows.
SRS-ECU
Terminal No.
Destination of harness Corrective action
1, 2, 3, 4 Instrument panel wiring harness → Front wiring harness → Front
impact sensor
Repair or replace each wiring
harness
7 Instrument panel wiring harness → Earth
8 Instrument panel wiring harness → Combination meter
(SRS warning lamp)
9, 10 Instrument panel wiring harness → Front passenger's air bag
module
11, 12 Instrument panel wiring harness → Clock spring → Driver's air bag
module)
Repair or replace the dash wiring
harness. Replace clock spring.
13 Instrument panel wiring harness → Junction block (fuse No.8)
Repair or replace each wiring
harness
16 Instrument panel wiring harness → Junction block (fuse No.6)
h
arness.
20 Instrument panel wiring harness → Diagnosis connector
21, 22 Body wiring harness → Side air bag module (L.H.)
23, 24 Body wiring harness → Side air bag module (R.H.)
27, 28 Body wiring harness → Seat belt with pre-tensioner (R.H.)
29, 30 Body wiring harness → Seat belt with pre-tensioner (L.H.)
34, 35, 36 Body wiring harness → Side impact sensor (L.H.)
40, 41, 42 Body wiring harness → Side impact sensor (R.H.)
SRS-ECU connector