MANUAL TRANSMISSION ± Transmission Control
22-6
REMOVAL SERVICE POINT
A TRANSMISSION CONTROL LEVER ASSEMBLY
REMOVAL
1. Support the transfer with a transmission jack, and then
remove the transmission mount crossmember installation
bolt.
2. Lower the transmission until the transmission control lever
assembly installation bolts can be removed.
3. Remove the bolts, and then remove the transmission
control lever assembly.
INSTALLATION SERVICE POINTS
A STOPPER PLATE INSTALLATION
Install the stopper plate as shown in the illustration.
B TRANSFER CONTROL LEVER ASSEMBLY
INSTALLATION
1. Eliminate adhesive adhered to the transfer control lever
assembly installation bolts.
2. Use a tap (M8 1.25) to eliminate adhesive adhered
to the threaded holes of the control housing, and then
clean the holes with a compressed air.
3. Apply the specified adhesive to the transfer control lever
assembly installation bolts, and then install the transfer
control lever assembly.
Specified adhesive:
3M Stud Locking No.4170 or equivalent
Transmission
mount cross-
member instal-
lation bolt
Front of
vehicle
To Next Page
Loading...
