MANUAL TRANSMISSION ± Transmission Control
22-7
C STOPPER BRACKET ASSEMBLY INSTALLATION
1. Eliminate sealant and adhesive adhered to the stopper
bracket assembly installation bolts.
2. Use a tap (M8 1.25) to eliminate adhesive adhered
to the threaded holes of the stopper bracket assembly
installation nuts, and then clean the holes with a
compressed air.
3. Apply the specified sealant to the stopper bracket assembly
installation bolts (A shown in the illustration) and the
specified adhesive to the threaded part of the stopper
bracket assembly installation bolts (B shown in the
illustration), and then install the stopper bracket assembly.
Specified sealant (A):
3M ATD Part No.8660 or equivalent
Specified adhesive (B):
3M Stud Locking No.4170 or equivalent
A
B
To Next Page
Loading...
