MANUAL TRANSMISSION ± Transmission and Transfer Assembly
22-8
TRANSMISSION AND TRANSFER ASSEMBLY
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Transmission Oil and Transfer Oil Draining and
Refilling (Refer to P.22-2, 3.)
Transmission Control Lever Assembly and Transfer
Control Lever Assembly Removal and Installation
(Refer to P.22-4.)
Front Propeller Shaft and Rear Propeller Shaft
Removal and Installation (Refer to GROUP 25.)
Front Exhaust Pipe and Catalytic Converter Removal
and Installation (Refer to GROUP 17 ± Emission
Control.)
Shift Lever Operation Check <only after installation>
Instruments Operation Check <only after installation>
48 Nm
48 Nm
19 Nm
6
1
2
5
4
30 Nm
7
3
6
48 Nm
48 Nm
48 Nm
5
Removal steps
1. Clutch release cylinder installation
bolts
2. Starter motor installation bolts
3. Oil pan connection bolts
Adapter (Refer to GROUP 32 ±
Transmission mount.)
4. Transmission harness connector
connection
5. Transmission assembly upper cou-
pling bolts
6. Transmission assembly lower cou-
pling bolts
7. Transmission and transfer assembly
To Next Page
Loading...
