AUTOMATIC TRANSMISSION ± On-vehicle Service
23-37
4. Repeat the procedure in step 2.
NOTE
Drain the A/T fluid from the cooler hose 6.0 at least
in step 2. Then drain the A/T fluid a little and check the
A/T fluid for dirt.
If it has been contaminated, repeat the steps 3 and 4.
5. Follow the automatic transmission fluid replacement
procedure from the step 3.
KICKDOWN CABLE CHECK AND ADJUSTMENT
1. Release the accelerator pedal.
2. Loosen the adjusting nut or adjusting bolt. Move the outer
cable of the kickdown cable to adjust the clearance (A)
between the inner cable stopper and dust cover end to
the standard value, and then tighten the adjusting nut
or adjusting bolt to secure the kickdown cable.
Standard value: 0.8 ± 1.5 mm
Caution
Adjust the accelerator cable assembly after the
kickdown cable adjustment.
INHIBITOR SWITCH CONTINUITY CHECK
Posi-
Terminal No.
tion
1 2 3 4 5 6 7 8 9 10
P
R
N
D
2
L
A
Adjusting
bolt
Dust
cover
Inner cable
stopper
Inhibitor switch
To Next Page
Loading...
