PROPELLER SHAFT ± Propeller Shaft
25-6
B JOURNAL BEARING REMOVAL
1. Using the special tools, press in the journal bearing to
remove the journal bearing on the opposite side.
2. Set the special tools reverse to press in the journal. Then,
pull out the journal bearing pressed in step 1.
Caution
Do not tap the journal bearing to remove. Tapping
the journal bearing will upset the balance of the
propeller shaft.
REASSEMBLY SERVICE POINTS
A JOURNAL BEARING INSTALLATION
1. Using the special tool, press in the journal bearing to the
yoke until the snap ring groove can be seen completely.
2. Using the special tools, press in the journal bearing on the
opposite side to the yoke.
Caution
Press in the journal bearing straight, or the journal
could damage the inside of the journal bearing.
3. Align the mating marks on the yoke and propeller shaft. On
the propeller shaft side, install the journal bearing in the
same steps of 1 and 2.
B SNAP RING INSTALLATION
1. Install the snap ring to one side of the journal.
2. Using the special tool, press in the journal bearing toward
the snap ring from the opposite side which the snap ring
has been installed on.
MB990840
MB990840
MB990840
MB990840
MB990840
MB990840
Groove for snap ring
MB990840
MB990840
MB990840
Snap ring
To Next Page
Loading...
