PROPELLER SHAFT ± Propeller Shaft
25-7
3. Install the snap ring on the opposite side and measure the
clearance of the snap ring groove with a thickness gauge.
Standard value:
Front propeller shaft (A) 0 ± 0.06 mm
Rear propeller shaft (A) 0.02 ± 0.06 mm
Caution
Always use snap rings of the same thickness on both
sides.
4. If the standard value(s) are not met, use other snap rings
to adjust the clearance.
Items Thickness mm Identification
colour
Front propeller shaft,
1.28 ±
Rear propeller shaft
1.31 Yellow
1.34 Blue
1.37 Purple
Rear propeller shaft 1.40 Brown
Snap ring
A
To Next Page
Loading...
