FRONT AXLE ± Differential Carrier
26-35
REASSEMBLY
34 ± 39 Nm*
186 Nm
78 ± 88 Nm
35 Nm
59 ± 69 Nm
49 Nm
Differential gear set Final drive gear set
Reassembly steps
1. Differential carrier
" AA 2. Oil seal
" BA 3. Drive pinion front bearing outer
race
" CA 4. Drive pinion rear bearing outer
race
" DA D Drive pinion height adjustment
5. Drive pinion
6. Drive pinion front shim (for drive
pinion height adjustment)
7. Drive pinion front bearing inner
race
8. Drive pinion spacer
" EA D Drive pinion rotation torque adjustment
9. Drive pinion rear shim (for drive
pinion rotation torque adjustment)
10. Drive pinion assembly
11. Drive pinion rear bearing inner race
12. Oil seal
13. Companion flange
14. Washer
15. Self-locking nut
16. Differential case
" FA D Differential gear backlash adjustment
17. Side gear spacer
18. Side gear
19. Pinion washer
20. Pinion gear
21. Pinion shaft
" GA 22. Lock pin
" HA 23. Drive gear
" IA 24. Side bearing inner race
25. Side bearing outer race
" JA D Final drive gear backlash adjustment
26. Side bearing spacer
27. Differential case assembly
28. Bearing cap
29. Vent plug
30. Cover
31. Drain plug
32. Filler plug
NOTE
The fasteners marked by * should be tightened when the
differential gear oil is applied.
To Next Page
Loading...
