FRONT AXLE ± Differential Carrier
26-39
" EA DRIVE PINION ROTATION TORQUE
ADJUSTMENT
Adjust the drive pinion rotation torque by using the following
procedure:
1. Insert the drive pinion into the gear carrier, and then install
the drive pinion spacer, the drive pinion rear shim, the
drive pinion rear bearing inner race, and the companion
flange in that order.
NOTE
Do not install the oil seal.
2. Use the special tool to hold companion flange, and then
tighten the self-locking nut to the specified torque.
3. Measure the drive pinion rotation torque (without the oil
seal) by using the special tool.
Standard value:
Bearing division Bearing lubrication Rotation torque Nm
New None (With
anti-rust agent)
0.88 ± 1.17*
1
0.29 ± 0.49*
2
New/reused Gear oil applied 0.39 ± 0.49*
1
0.147 ± 0.245*
2
NOTE
*
1
: A/T
*
2
: M/T
4. If the drive pinion rotation torque is not within the range
of the standard value, adjust it by replacing the drive
pinion rear shim(s) or the drive pinion spacer.
NOTE
When selecting the drive pinion rear shims, if the number
of shims is large, reduce the number of shims to a minimum
by selecting the drive pinion spacers. Also, select the
drive pinion spacer from the following two types.
186 Nm
MB990850
MB990326
Identification
colour
A
To Next Page
Loading...
